RF Dream-color Controller

Detailed Product Description

Summarization
RF Dream-color controller is designed for led production which use LPD6803 as driver, it has 256*256*256 grayscale , Length setup function and Power-fail memory function, you could choose it freely in a lot of programs, meanwhile, you could adjust all kinds of dynamic lighting changes by RF remote controller. It is very useful for light box advertisement, stage light, house decorating and so on.
    

 

Technical parameters
● working temperature:-20-60℃
● supply voltage:DC12V 
● external dimension:L94ΧW59ΧH25 mm
● packing size:L145ΧW95ΧH50 mm
● net weight:205 g
● gross weight:235 g
● rated power:2.2W
● output: two groups SPI signal

 

 

External Dimension

 

 

 

 

 

Interface Specification

       

  Power input interface:

 

 

 Adopt conventional DC power socket as power input interface.

                   

          

 

 

Load output interface:

 

 

 

 

 Adopt 4-pin Connector pin. 

 

  

 

Direction for use

1. Connect the load wire at first, following by the power wire; Please ensure short circuit can not  occur between connecting wire before you turn on the power.

 

  2.    There are eight buttons altogether on controller panel, and every button function as follows:

ON/OFF button, it can open or close led anytime, when led is on the state of closing, the LCD will display IC NUMBER: ***,  *** is the value of current setting.

Play/pause button, when you want to see the static effect of led ,you may press this button to pause.

Adding button, to add the IC NUMBER, the maximum is 255 (510 groups of RGB)

Reducing button, to reduce the IC NUMBER, the least number is 16 (32 groups of RGB);

Program choosing button, up direction, there are 84 programs in all.

Program choosing button, down direction;

Speed-down button, there are 100 steps in all;

Speed up button.

 

  3.    There are six buttons altogether on remote controller panel, and every button function as follows:

   ON / OFF: you could turn on or off load output at any time;

   MODE: mode button, you can choose playing or pausing mode, and observe the static results of LED in the state of suspension mode .

   S +: the button to increase the rate of change;

   S-:  the button to slow down the rate of change, a total of 100 steps;

   B +: procedures for the selection key and up choice, a total of 84 procedures;

   B-:  procedures for the selection key, down choice.

 

    4.  The description of signal output interface: V, C, D, G correspond with the signal of 6803,which is VCC,CLOCK,DATA,GND.

Program description:(Condition: A1-Blue LED;A2-Red LED;A3-Green LED)

 

5. Standard color changes as follows:

 

 

Typical Application